Abstract
Self-designed electrokinetic setups were constructed to examine the differences in electromigration and electroosmotic rates in both sand and clay. Two dyes were analyzed separately to measure these phenomena within these two media types. The dyes used were a red food coloring (primary compound Allura Red) and a green food coloring (referred to as a "blue dye,"as its migrating component was C-phycocyanin (C-PC) via Spirulina Blue extract). The power supply had a 30 V output with a measured 9.36 ± 0.04 mA current (0.054 mA/cm2) output. Electromigration was readily apparent for the red dye in both sand (9.12 ± 1.57 cm/d) and clay (0.93 ± 0.16) cm/d. It was also observed for the blue dye (C-PC) in sand (7.28 ± 0.57 cm/d) but not in clay. A confirmation experiment for the blue dye in sand was performed at an identical voltage but a slightly lower current output (0.040 mA/cm2), and the migration rate was found to be similar, at 6.60 ± 0.20 cm/d. For the blue dye in clay, the migration rate proceeded toward the cathode at 0.17 cm/d. Calculations indicate this phenomenon to be due to electroosmosis but may be due to a weak electromigration of the dye in protonated form.
Original language | American English |
---|---|
Article number | 04020071 |
Journal | Journal of Hazardous, Toxic, and Radioactive Waste |
Volume | 25 |
Issue number | 2 |
DOIs | |
State | Published - Apr 1 2021 |
ASJC Scopus subject areas
- Environmental Engineering
- Environmental Chemistry
- General Chemical Engineering
- Water Science and Technology
- Geotechnical Engineering and Engineering Geology
- Waste Management and Disposal
Keywords
- Allura Red
- Amphoteric
- Amphoteric dye
- Anionic dye
- C-phycocyanin
- Dye migration
- Electrokinetics
- Electromigration
- Electroosmosis
- FD &C Red 40
- Phycocyanin
- Spirulina Blue